From Annandale to the hills around Round Valley, we design and engineer additions, second stories and renovations for Clinton Township homeowners.
Clinton Township covers about 34 square miles of Hunterdon County, incorporated in 1841 and named for New York governor DeWitt Clinton. It includes Annandale and other communities and surrounds the borough of Lebanon. Round Valley Reservoir, created in the 1960s and the second deepest in the state, sits within the ring shaped Cushetunk Mountain the township shares with Readington.
Hillside and rural lots and a mix of older and later homes make every addition specific. Our engineers check the existing structure and the site first, then design the new work with the architecture.
Licensed architects and professional engineers on one team, one contract and one set of signed and sealed drawings. See all of our services.
Rear, side and wraparound additions for kitchens, family rooms and primary suites, with the existing house evaluated by our engineers.
New floors over ranches, capes, garages and one story wings, with foundations and framing checked and reinforced as needed.
Whole house and partial renovations, wall removals and open plans, basements and attics, with structure and systems designed in house.
Ground up single family homes and teardown rebuilds, from site planning to sealed construction drawings.
Decks, covered porches, pergolas and garages engineered for footings, ledgers and loads.
Beam replacements, foundation fixes and engineer's letters for homeowners, buyers and insurers.
In New Jersey, most additions and structural renovations need zoning approval from the town before the construction permit, and the construction permit itself is reviewed under the state Uniform Construction Code. When a design needs relief from a setback, coverage or height limit, it goes to the town's land use board for a variance hearing.
Hilly lots near Cushetunk Mountain and the reservoir bring slope, rock and drainage questions. We study the site early and design footings and retaining walls for actual conditions.
Rural lots raise septic and well questions. We address them before design.
However your project is approved, we deliver signed and sealed drawings to you, support you and your contractor through the permit submission and answer the building department's review comments in house. Read how a project moves from consultation to close out on our process page.
Often, yes. We check the existing foundation and framing first.
Yes. We design footings, retaining walls and drainage for the site.
We deliver signed and sealed drawings and support you or your contractor in the permit submission.
See a fixed design fee in about two minutes, or book a consultation and we will visit your home.