From Whitehouse Station to Three Bridges and Stanton, we design and engineer additions, renovations and new homes across Readington Township.
Readington is the largest township in Hunterdon County at nearly 48 square miles, formed by royal charter in 1730, with villages including Whitehouse Station, Readington Village, Three Bridges, Stanton and Potterstown. The South Branch of the Raritan forms its southern boundary and the Lamington River and Rockaway Creek its northern one. Taylor's Mill, from about 1760, is on the National Register, and Solberg-Hunterdon Airport hosts the state's ballooning festival.
Village homes, farmhouses and later subdivisions each call for a different approach to an addition. Our engineers check the existing structure and site first, then design the new work with the architecture.
Licensed architects and professional engineers on one team, one contract and one set of signed and sealed drawings. See all of our services.
Rear, side and wraparound additions for kitchens, family rooms and primary suites, with the existing house evaluated by our engineers.
New floors over ranches, capes, garages and one story wings, with foundations and framing checked and reinforced as needed.
Whole house and partial renovations, wall removals and open plans, basements and attics, with structure and systems designed in house.
Ground up single family homes and teardown rebuilds, from site planning to sealed construction drawings.
Decks, covered porches, pergolas and garages engineered for footings, ledgers and loads.
Beam replacements, foundation fixes and engineer's letters for homeowners, buyers and insurers.
In New Jersey, most additions and structural renovations need zoning approval from the town before the construction permit, and the construction permit itself is reviewed under the state Uniform Construction Code. When a design needs relief from a setback, coverage or height limit, it goes to the town's land use board for a variance hearing.
Properties along the South Branch, the Lamington and Rockaway Creek may be near mapped flood areas or stream buffers. We check those before design.
Larger lots bring septic, well and grading questions. We work those out at the start.
However your project is approved, we deliver signed and sealed drawings to you, support you and your contractor through the permit submission and answer the building department's review comments in house. Read how a project moves from consultation to close out on our process page.
Often, yes. We check the existing foundation and framing first.
We check current flood mapping before design and plan for any requirements that apply.
Our instant quote gives you a fixed design fee, which we confirm after a site visit.
See a fixed design fee in about two minutes, or book a consultation and we will visit your home.